Wireless Smart Curtain Controller Function Description and Installation Steps

1. Features

(1) It is small in size and easy to install. It can be installed directly in the 86 bottom box.

(2) To achieve dual control, the wall can be wirelessly controlled or manually controlled using the touch switch on the panel.

(3) When power is supplied after a power failure, the curtain remains in the state before the power failure.

(4) With calibration function, suitable for curtains with different width (≤12m).

2 function switch use

(1) Registration mode. Switch the function switch to the "SET" position register to enter the registration mode.

(2) Relay mode. Put the function switch to the "relay" position stop, that is, the device has a relay function.

(3) Normal work. Set the function switch to the “normal” position and the device is operating in normal mode.

3. Commissioning steps

(1) Registration system identification code and unit code (Only the system identification code can be registered for wireless control).

1 Enter the registration mode: Set the function switch to the “SET” position.

2 registered system logo vortex: Bo controller arbitrary button, two lights flashing immediately, indicating that it has entered the setting state. Use the smart handheld controller or central control host to register the system ID code. After the registration is successful, the light stops flashing.

3 Registered unit code: Press any button of the handheld controller, the two indicators will flash immediately, indicating that it has entered the setup state. Use the smart handheld controller or central control host to register the system ID code. After the registration is successful, the light stops flashing.

4 After the registration is completed, switch the function switch to the “normal” position.

(2) According to the actual needs of the system, if the device needs to open the relay function, the function switch dials the "relay operation" mode.

(3) Curtain calibration. Installation requires that the controller be calibrated for different curtain widths. Specific operation: press the "off" button first, all the curtains closed (if not all closed, you can all close the curtain hand-drawn). At the same time, press and hold the two buttons on the panel for more than 2 seconds and then release it. The two indicators flash and the calibration mode is entered. Manually press the "ON" button to open the curtain. Immediately after the curtains are fully opened, press the "ON" button again. The curtains will stop immediately and the calibration is completed.

(4) Use the smart handheld controller or central control host wireless operation control to test whether the electric curtain is controlled, and the central control host can display the change of its controlled state.

(5) Operate directly on the wireless smart blind controller to test whether its working status is normal and can display status information on the master controller.